ติดต่อเรา
ที่อยู่อีเมลของคุณจะไม่ถูกเผยแพร่ ช่องที่ต้องกรอกถูกทำเครื่องหมายไว้ -
1. Preparation before installation
Choose the right fan: Choose the appropriate DC Automotive Axial Fan model and specifications based on the specific needs of the vehicle and the design requirements of the cooling system.
Check accessories: Make sure the fan you purchase comes with complete installation accessories, such as screws, nuts, washers, etc.
Tool preparation: Prepare the tools required for installation, such as screwdrivers, wrenches, electric drills, etc.
2. Installation steps
Determine the installation location: Determine the installation location of the fan according to the design requirements of the vehicle cooling system. Normally, the fan should be installed in a suitable location in the engine compartment so that it can effectively remove the heat.
Fix the mounting bracket: Use screws and nuts to fix the fan's mounting bracket in the predetermined position. Make sure the bracket is installed firmly and not easy to shake.
Install the fan: Place the fan on the mounting bracket and secure it with screws and spacers. Pay attention to ensure that the contact surface between the fan and the bracket is flat to avoid noise or vibration caused by improper installation.
Connect the power cord: Connect the power cord to the fan's motor cord according to the fan's wiring diagram. Make sure the connection is firm and not easy to fall off, and pay attention to the insulation of the power cord to prevent short circuit or leakage.
Test operation: Before connecting the power supply, check whether the fan rotates flexibly and whether there is any abnormal noise. Then, plug in the power and test the operation of the fan. If there is any abnormality, the power should be cut off immediately for inspection.
3. Configuration optimization
Temperature sensing control: Use temperature sensors inside the vehicle, such as engine temperature, coolant temperature, etc., to intelligently control the start and stop of the fan. Set an appropriate temperature threshold to ensure that the fan can start in time to dissipate heat when the engine temperature is too high, and automatically stop when the temperature is low to save energy.
Speed curve adjustment: Adjust the fan speed curve according to vehicle usage and cooling needs. In high load operation or high temperature environment, increase the fan speed to increase the heat dissipation effect; in low load or low temperature environment, reduce the fan speed to save energy and reduce noise.
Delayed shutdown function: After the engine is turned off, set the fan delayed shutdown function to ensure that the heat in the engine compartment can be fully dissipated and avoid damage to the engine caused by heat accumulation.
Voltage stability: Ensure stable voltage is provided to the fan to avoid voltage fluctuations affecting fan performance. If necessary, a voltage stabilizer or filter can be installed to ensure voltage stability.
Energy-saving mode: If the fan supports energy-saving mode, this mode can be turned on according to the actual situation. Energy saving mode usually automatically reduces the fan speed after running for a period of time to save energy and extend the life of the fan.
Vibration reduction measures: When installing the fan, take appropriate vibration reduction measures, such as using vibration reduction pads or vibration reduction brackets, to reduce vibration and noise when the fan is running.
Balance adjustment: Make balance adjustments to the fan to ensure that it does not produce excessive vibration and noise when running at high speed. If the fan is unbalanced during operation, the balance should be adjusted in time.
